Unpacking & Setup

The TankerTherm 123 ships partially crated to protect the distribution manifold plumbing. Follow these steps carefully to avoid damage during unpacking.

Before you unpack

Verify the shipment

Two items are loose-packed inside the cabinet. Confirm both are present before proceeding:

  • Suction filter

  • Suction tube/hose assembly

The red expansion vent hose is factory-installed at the storage tank end. The free (drum) end is fitted with the drum vent hose-barb described below — connect this to your supply drum during installation.

Removing the crating

Use care when removing crating

Blocking strips are wedged behind the manifold. Sliding them out carelessly can damage distribution plumbing.

  1. Remove the crating using special care when sliding out blocking strips.

  2. To remove the cabinet door:

    1. Remove the two bolts that secure the door near the bottom on either side.

    2. Pull the door out at the bottom.

    3. Gently slide the door down and away from the top lid.

Installing loose-packed components

Rear of the TankerTherm 123 cabinet showing two labelled brass hose barbs, OVERFLOW and REFILL IN, near the top of the rear panel
Figure 1. Rear of the unit — the OVERFLOW and REFILL IN hose barbs for the supply-drum hoses are at the top of the rear panel
Rear of a TankerTherm 123 beside a white 55-gallon supply drum, with a blue refill hose and a red overflow hose running from the top of the rear panel down into the drum, and two black hoses running to a tanker
Figure 2. Supply drum hookup — the refill hose (blue here) runs from the drum to REFILL IN through the suction filter, and the red vent hose runs from OVERFLOW back to the drum. Illustration: the unit is a photograph, the surroundings are computer-generated to show a typical installation.

Install the two loose-packed items (suction filter, suction tube/hose assembly) into the bulkhead fittings.

Prevent bulkhead rotation

Before tightening any fitting, secure the bulkhead fitting from rotation with a crescent wrench. Rotating a bulkhead can damage internal connections and void your warranty.

Drum vent hose-barb fitting

The fitting at the drum end of the factory-installed red expansion vent hose connects the storage tank’s atmospheric vent to your supply drum so that any expansion overflow drains back into the drum.

The drum vent 5/8″ hose-barb fitting is designed for re-use on each successive drum. When swapping drums:

  • Screw the fitting into the 3/4″ NPT plug fitting hand tight

  • Do not use thread sealant

  • Do not use a hose clamp

Next steps

After completing mechanical setup, proceed to: